![]() ![]() However, if your skateboard’s grip tape is starting to wear, it might be time to remove it and apply a fresh new sheet. Skaters usually don’t change their grip tape, they change boards. If you’re replacing old grip tape with a fresh sheet, we cover tips for removing the old material in the next section.įor more useful information about grip tape, check out our article on “ How To Choose Grip Tape”.You also want to avoid cutting the grip tape to your deck size before applying it doing this means you have to line the grip up perfectly when you stick it down, which can be very tricky.However, if some small air bubbles do appear, you can try pushing them out over the edge of the deck or piercing them with your utility knife/razor blade. As mentioned above, pressing the grip tape down slowly and firmly from one side to the other helps avoid air bubbles from forming.Cut away any excess material and you’re all done.Then, take the screws from your trucks and poke them through these holes, ensuring you puncture the grip tape. Start by flipping your board over so you can see the holes in the deck.The last step is to poke holes through the grip tape where your trucks will be mounted. All that’s left to do is sand down the edges or use your screwdriver to round them down a second time – this helps to stop the grip tape from peeling off. ![]() Following this white line, take your utility knife or razor blade and cut the excess tape off the deck, holding the knife at a slight angle to give you a neat edge.The harder you press, the more visible your line will be. As you do this, a white line should begin to appear – this is your “stencil”, which shows you where to cut. Take a screwdriver or skate tool and use it to rub/press down the edges, making your way around the entire deck.This is a simple process to help guide you with cutting. Cutting the Edges of Grip Tapeīefore you cut the edges, you’re going to need to mark them. Once the entire sheet has been pressed down, you can prepare the edges for cutting. Press the tape down slowly and firmly, little by little, starting at one side and moving to the other (much like when you apply a screen protector to a cellphone), as this helps to avoid air bubbles.Remove the backing from the grip tape and place the sheet sticky-side down onto your clean, dry deck, making sure you still have excess grip tape hanging over the edges of the board.If everything is in check, you can move on to the next step: adhering it to the deck. You also want to ensure that the grip tape extends an extra inch or two over the edge of the skateboard so that you’ve got some extra tape to work with. Lay the sheet of grip tape over the deck and make sure it’s large enough to cover the entire board. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |